Wave Vocoder: Single Notes vs. Chords

I'm using Drambo's Wave Vocoder. With other vocoders, if you have the polyphony set to accommodate say 3 voices, then you play a single note, the vocoder will sound a single note, not a chord. In Drambo, if I set the Voices to 3, I'm unable to sound a single note. Only chords will play. Is there a way to make it play a single note sound *OR* a chord, based on the notes?

Comments

  • edited October 2022

    Like with any oscillator, you'll need a processor that can isolate voices using the polyphonic gate signal, typically an ADSR 😉

Sign In or Register to comment.