Midi feedback with p-locked parameter while playing problem
While stopped , when holding a note in the step sequencer with a p-locked parameter that is mapped to a midi controller(MFT) with feedback the knob LEDs update correctly to show the value.
but if the project is playing the LED value only shows briefly when a note is held then goes black (it does work correctly if only one p-lock note is in the sequence)
Comments
If I understand you correctly, that's the way p-locks work, and the MFT is simply reflecting what's really happening. P-Locks are only in effect until the next note arrives.
A parameter has its actual value and its p-locked value tied to a note.
when you hold that p-locked note with your finger the parameter updates with an overlay to show the p-locked value . When you release your finger the overlay disappears and the parameters unaffected value is shown.
when touching the note and showing the p-lock value the value on the MFT updates to show this value while held . Or at least that is what is supposed to happen but it fails in the condition I mentioned above .
I'd also prefer to keep the p-locked value shown as long as I'm holding the step, that just makes sense.
Me too.