Extend gate length past sequence end
I am wondering about is if there is a way to make a note on the sequencer run past the end of the sequence.
As an example, on my OP-Z, if I place a note on say, step 14, I can run it for up to 15 more steps (so it would continue back through the next loop of the sequence and stop at step 13 but if I add a step in step 14 of the Drambo sequencer, I can only figure out how to run it for another 2 steps, even if I pop into the “comp” section and set the gate longer or to inf.
Thanks in advance!