Xequence CC to mapped Drambo knobs?
I’ve got Xequence 2 sending notes to Drambo fine. I have a midi controller knob mapped to a mix knob in Drambo for a track and that works fine in Drambo. I record this midi cc info from the controller into Xequence which then sends that to Drambo. But Drambo does not respond to this CC like it responds to my controller directly. I can see Drambo is receiving the cc info on the main track with a monitor.
How to send recorded CCs so that Drambo responds via a midi mapping? Or how to get Drambo to listen to Xequence like it’s a midi controller? Right Drambo hears Xequence but doesn’t seem take it seriously haha 😄
Comments
Each MIDI mapping includes the source port that the MIDI message came from, otherwise you wouldn't be able to use multiple controllers with identical messages for different purposes.
BTW, if you can see the incoming message on the main track with MIDI Monitor, it means that the message isn't mapped yet, otherwise it would be filtered before it even reaches the track.
Ok, so to be sure, the source port is not viewable/editable in the mapping like the channel and CC #?
Exactly, but this is a feature that's likely coming with the next release.