"Enabled" module setting does not seem to work in all modules
I just noticed that the "Enabled" module setting does not seem to work in all modules:
While I can disable an LFO, the CV quantizer module is still continuing it's work even after I tried to disable it by sliding "Enabled" to the left. The same for a simple knob: Disabling the module gives it a darker appearance but I can still twist the knob and the output value changes.
My expectation was that a disabled quantizer simply passes the input signal unmodified through, and a disabled knob freezes and cannot be twisted anymore.
Is there anything wrong with my Drambo installation or is this a known limitation / bug ?
Comments
Enabled modules work well for me.
I often have trouble with the knobs modules though, even now when testing this to see how to emulate your issue, but I haven't used them much to know fully what i might be missing.
I often use the Enabled setting, and the dials on any module that's enabled or disable, to the best of my knowledge, always can be twisted, but do get passthrough if you disable that module via the enabled setting.
The strum module is another one. When inactive it still strums.