I want an 8-bit (0-255 steps) value table where each step value can be -1 -- 1(Oscillator), 0-127 (Midi CC) and 0-255 (Step Jump etc) and +/-127 (8-bit oscillator) that can also be used as an oscillator, modulation source, and a step reset to any off the steps. (think 'start phase = step 0-255).
This could also be used to precisely set parameters like oscillator selection, slice number etc. :)
Wouldn't factory presets for the Graphic Shaper be the best place for these?
I agree with @giku that there are never enough waveforms to satisfy everybody and If it can be built fairly easily with 2, 3 or 4 modules then that should be acceptable.
Features in modules that are used very often are worth to be discussed though, IMHO.
Comments
LFO saw up/down through bit redux?
i want it out of the box
Its a way I want to avoid... we have waveshaper and bitredux.
If I added this to LFO, then: separate waves for 3,4,5,6 steps ... then someone will ask for smoothed steps etc..
I want an 8-bit (0-255 steps) value table where each step value can be -1 -- 1(Oscillator), 0-127 (Midi CC) and 0-255 (Step Jump etc) and +/-127 (8-bit oscillator) that can also be used as an oscillator, modulation source, and a step reset to any off the steps. (think 'start phase = step 0-255).
This could also be used to precisely set parameters like oscillator selection, slice number etc. :)
Wouldn't factory presets for the Graphic Shaper be the best place for these?
I agree with @giku that there are never enough waveforms to satisfy everybody and If it can be built fairly easily with 2, 3 or 4 modules then that should be acceptable.
Features in modules that are used very often are worth to be discussed though, IMHO.