"Audio Output" Module only mono?
I recently started to do some experiments with a "quadrophonic" setup (in Dr. Standalone, btw.).
I did setup two main-busses ("front" and "rear") sending audio to USB 1+2 resp. USB 3+4.
My tracks are set to send audio to "front", while inside the tracks I wanted to put "Audio Output"-modules
to send audio to the "rear"-bus (pre-fade). The whole setup works so far, but the "Audio Output"-module seems to be mono.
The signal is sent to the left and right channels of the "rear" bus, but it's only the left part of the input.
(Put a "Pan"-modul before the "Audio Output" to find out).
Is this an intended feature, a bug or am I doing something wrong?
cheers
electronicsfordogs
Comments
Confirmed here
@giku
@Gravitas:
yep, thats how I'm currently doing it. Well, actually I'm sending the two monosignals to two monobusses which then feed the outputs.
This leaves room for some further busprocessing...
Still, it would be a little bit easier to have this in stereo, wouldn't it? 😉
cheers
@Gravitas :
all good.
try this for some fine crazyness:
🙊