I have both pots and encoders in my set up, both controlling the same parameters in Drambo.
At the moment no matter what setting I choose I get value jumps which is quite annoying. Is there a way of mitigating this?
Takeover setting was reported not working.
With encoders you can choose relative mode (if supported by your controller) to avoid jumps. (this is not the same as takeover, which is a feature that can be enabled in absolute mode)
Ah ok, that makes sense. I didn’t realise there were issues or rather I may have heard and forgotten about it! 😇
Comments
Takeover setting was reported not working.
With encoders you can choose relative mode (if supported by your controller) to avoid jumps. (this is not the same as takeover, which is a feature that can be enabled in absolute mode)
Ah ok, that makes sense. I didn’t realise there were issues or rather I may have heard and forgotten about it! 😇