Removing p lock not working
I have some plocks for the dry wet control of a reverb ( insert effects on a tra k )
The pattern is 8 bars long , but the plocks just stay in place after explicitly selecting ‘ remove plocks’
It’s not just the build,in reverb , also happens with 3th part ystuff ( bram bros trouble maker ) , plocks just stay in place
Comments
There is def. Something weird going,on , plocks are only removed for the first bar .
verry weird
Most def a bug
steps to reproduve
-insert an osc + amp env
-create 1 bar pattern and fill with notes of same pitch
No one ?
just plock any parameter over 2 bars , double click the p-locked parameter and choose remove plocks .
only the first bar of plocks are erased
@gentleclockdivider yes, reproduced here
@giku P-Locking issue.
Another P-Lock thing that I can't wrap my head around,
If a clip is ON and while P-Locking it by it's assigned CC, say you Send CC 0 value 127, P-locking is engaged so you can go ahead and set all the needed parameters, after un(P-locking) the clip, the clip itself turns off, repeat the above and the clip is back on again.
But when manually doing this then the clip always returns to the state where it previously was in?
I've tried all the possible controller types and all the possible incoming CCs, either a normal toggle - first click value 127, second 0, or both clicks value 127, but it always keeps shuffling through ON/Off states of the clip while remotely P-Locking.
Me too… +1
Also is anyone seeing a bug with 8 midi out? I keep setting hammerhead and only track 2 and 9 are output,1-7 remain silent
I'm not seeing that here @FearAndLoathing. (I assume you don't really mean midi out, but audio.)
Can you post a screenshot or two of your setup?
Thanks man; I figured it out…it was a weird glitch with my interface . Interpolicous helped a lot